How is the syntax for use of the push Service?
I want to push data from Robonect to my Domoticz home automation system.
When I in a web browser do this «https://10.0.0.20/json.htm?type=command¶m=udevice&idx=957&svalue=TEST», the value of index 957 is set to TEST successful.
If I in Robonect Push-Service do the same, Select POST and the same URL as above and click «execute» the result is: «Transmission successfully (HTTP-Response: 200)» but no change in Domoticz. It should have set the value TEST regardless of triggers.
So How is this supposed to work?
And what value to replace TEST for the trigger (%s ?)?
(Also the length of the URL field is too short, should be longer to handle complex entry)
Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
. Achtung! Derzeit ist Robonect (noch) nicht mit dem Automower 305 ab Baujahr 2020 zusammen mit der neuen Mäher-FW MSW 41.4.0 kompatibel!
Aber: Im DailyBuild ist ein Patch enthalten, der getestet werden kann! (Stand 15.02.2024)
.
.Du hast Deinen Gardena-Mäher auf die Gardena-Firmware von 2023 aktualisiert?
. Testmöglichkeit für das Daily Build.
Das FW-Update am Mäher wird dennoch nicht empfohlen, da das Daily Build nach aktuellen Berichten von Beta-Testern noch keine vollständige Kompatibilität gewährleisten kann! (Stand: 15.02.2024)
Wir empfehlen, das Gardena-Update noch nicht durchzuführen!
.
.
How to use PUSH SERVICE (Beta 3)?
Moderator: Lampi
-
- Forum-Anfänger
- Beiträge: 3
- Registriert: Mi 3. Mai 2017, 07:53
- Mäher: Husqvarna Automower 310
- Firmware des Mähers (MSW): MSW 6.xx.xx
- Herstellungsjahr: 2016
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: 0.9d
Re: How to use PUSH SERVICE (Beta 3)?
Did you figure this OUT? Trying to get pretty much the same thing to work. Seems weird you've got no answers at all.
- Marco.Klose
- Forum-Nutzer
- Beiträge: 43
- Registriert: Di 19. Dez 2017, 10:03
- Mäher: Husqvarna Automower 310
- Firmware des Mähers (MSW): MSW 7.xx.xx
- Herstellungsjahr: 2017
- Robonect-Modul: Robonect Hx (Rev.4)
- Robonect Firmware: v1.2
Re: How to use PUSH SERVICE (Beta 3)?
If you want to receive the parameters via URL, you have to use the GET mode.