How is the syntax for use of the push Service?
I want to push data from Robonect to my Domoticz home automation system.
When I in a web browser do this «https://10.0.0.20/json.htm?type=command¶m=udevice&idx=957&svalue=TEST», the value of index 957 is set to TEST successful.
If I in Robonect Push-Service do the same, Select POST and the same URL as above and click «execute» the result is: «Transmission successfully (HTTP-Response: 200)» but no change in Domoticz. It should have set the value TEST regardless of triggers.
So How is this supposed to work?
And what value to replace TEST for the trigger (%s ?)?
(Also the length of the URL field is too short, should be longer to handle complex entry)
Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
. Achtung! Verwendet bitte für aktuelle Mäher bzw. falls ihr die Firmware eures Mähers kürzlich aktualisiert habt, den aktuellen Release-Candidate der Robonect-Firmware: https://fw.robonect.de/?latest Diese wird in ein paar Tagen als offizielle Firmware verfügbar sein. (Stand: 03.04.2024)
How to use PUSH SERVICE (Beta 3)?
Moderator: Lampi
-
- Forum-Anfänger
- Beiträge: 3
- Registriert: Mi 3. Mai 2017, 07:53
- Mäher: Husqvarna Automower 310
- Firmware des Mähers (MSW): MSW 6.xx.xx
- Herstellungsjahr: 2016
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: 0.9d
Re: How to use PUSH SERVICE (Beta 3)?
Did you figure this OUT? Trying to get pretty much the same thing to work. Seems weird you've got no answers at all.
- Marco.Klose
- Forum-Nutzer
- Beiträge: 43
- Registriert: Di 19. Dez 2017, 10:03
- Mäher: Husqvarna Automower 310
- Firmware des Mähers (MSW): MSW 7.xx.xx
- Herstellungsjahr: 2017
- Robonect-Modul: Robonect Hx (Rev.4)
- Robonect Firmware: v1.2
Re: How to use PUSH SERVICE (Beta 3)?
If you want to receive the parameters via URL, you have to use the GET mode.