You should consider:
Using a bigger part of battery's capacity - does not increase the area which can be mowed
- devreases lifetime of battery
Best implementation in my eyes would be if you can set EndOfCharge-voltage and EndOfMow-Voltage by using the already mentioned manual mode.
if you can decrease end of Charge voltage you can increase battery-lifetime which is optimal at 70% charging and discharging to 30% (ref:Wikipedia; ) In this case there are only 40% of capacity used!!)
At constant power consumtion during work there is also a constant factor ChargingTime/WorkTime what means during a week sum of working time is constant and no function of capacity. In real life there is a Little influence, because during Start and homecoming there is a Little time which is influenced by the count of charging events and therfore a function of used capacity. but this influence is normaly not big enough to be relevant.
if you can stop charging at 19.5 V this should increase LiIon lifetime significantly.
regards
Guenther
[V1.0 Beta 6]Charge larger battery
-
- sehr erfahrener Forum-Nutzer
- Beiträge: 106
- Registriert: Mo 17. Apr 2017, 14:23
- Wohnort: Main Taunus Kreis
- Mäher: Gardena smart SILENO
- Firmware des Mähers (MSW): MSW 7.xx.xx
- Herstellungsjahr: 2016
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: 1.0 Beta 7a
Re: Charge larger battery
+1
Where have you bought your battery?
Gesendet von meinem Mi-4c mit Tapatalk
Where have you bought your battery?
Gesendet von meinem Mi-4c mit Tapatalk
--- Gardena Sileno Smart mit Gleitscheibe....
-
- Forum-Nutzer
- Beiträge: 12
- Registriert: Sa 20. Feb 2016, 10:13
Re: Charge larger battery
+1
i bought an INTENSILO Li-Ion Akku 2500mAh (18V) when the original one was broken
i bought an INTENSILO Li-Ion Akku 2500mAh (18V) when the original one was broken
-
- Administrator
- Beiträge: 2907
- Registriert: Di 19. Jan 2016, 18:34
- Wohnort: Kiel
- Mäher: Gardena SILENO City 500
- Firmware des Mähers (MSW): MSW 11.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: stets die Allerneuste :-)
- hat sich bedankt: 1 Mal
- wurde gedankt: 60 Male
- Kontaktdaten: