You should consider:
Using a bigger part of battery's capacity - does not increase the area which can be mowed
- devreases lifetime of battery
Best implementation in my eyes would be if you can set EndOfCharge-voltage and EndOfMow-Voltage by using the already mentioned manual mode.
if you can decrease end of Charge voltage you can increase battery-lifetime which is optimal at 70% charging and discharging to 30% (ref:Wikipedia; ) In this case there are only 40% of capacity used!!)
At constant power consumtion during work there is also a constant factor ChargingTime/WorkTime what means during a week sum of working time is constant and no function of capacity. In real life there is a Little influence, because during Start and homecoming there is a Little time which is influenced by the count of charging events and therfore a function of used capacity. but this influence is normaly not big enough to be relevant.
if you can stop charging at 19.5 V this should increase LiIon lifetime significantly.
regards
Guenther
Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
. Achtung! Derzeit ist Robonect (noch) nicht mit dem Automower 305 ab Baujahr 2020 zusammen mit der neuen Mäher-FW MSW 41.4.0 kompatibel!
Aber: Im DailyBuild ist ein Patch enthalten, der getestet werden kann! (Stand 15.02.2024)
.
.Du hast Deinen Gardena-Mäher auf die Gardena-Firmware von 2023 aktualisiert?
. Testmöglichkeit für das Daily Build.
Das FW-Update am Mäher wird dennoch nicht empfohlen, da das Daily Build nach aktuellen Berichten von Beta-Testern noch keine vollständige Kompatibilität gewährleisten kann! (Stand: 15.02.2024)
Wir empfehlen, das Gardena-Update noch nicht durchzuführen!
.
.
[V1.0 Beta 6]Charge larger battery
-
- sehr erfahrener Forum-Nutzer
- Beiträge: 106
- Registriert: Mo 17. Apr 2017, 14:23
- Wohnort: Main Taunus Kreis
- Mäher: Gardena smart SILENO
- Firmware des Mähers (MSW): MSW 7.xx.xx
- Herstellungsjahr: 2016
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: 1.0 Beta 7a
Re: Charge larger battery
+1
Where have you bought your battery?
Gesendet von meinem Mi-4c mit Tapatalk
Where have you bought your battery?
Gesendet von meinem Mi-4c mit Tapatalk
--- Gardena Sileno Smart mit Gleitscheibe....
-
- Forum-Nutzer
- Beiträge: 12
- Registriert: Sa 20. Feb 2016, 10:13
Re: Charge larger battery
+1
i bought an INTENSILO Li-Ion Akku 2500mAh (18V) when the original one was broken
i bought an INTENSILO Li-Ion Akku 2500mAh (18V) when the original one was broken
-
- Administrator
- Beiträge: 2903
- Registriert: Di 19. Jan 2016, 18:34
- Wohnort: Kiel
- Mäher: Gardena SILENO City 500
- Firmware des Mähers (MSW): MSW 11.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: stets die Allerneuste :-)
- hat sich bedankt: 1 Mal
- wurde gedankt: 59 Male
- Kontaktdaten: