Hi
It looks like the Operational Hours->Mowing times not being updated when running in "Mowing time adjustment:->Extend Mowing Time". On the other hand Seek times are being updated.
Is anyone seen this or confirmed earlier? I can send more data/debug if needed/instructed.
Here are the details of my current firmware
Bootloader
Version: V1.0
Compiled: 14.12.2017 23:10
Comment: Release V1.0
WLAN
AT-Version: V1.6.0
SDK-Version: V2.2.0
Compiled: Unknown
ZeroConf
Version: V1.4
Compiled: 09.07.2019 22:49
Comment: ZeroConf V1.4
Application
Version: V1.1
Compiled: 25.0
9.2019 08:54
Comment: V1.1b
Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
. Achtung! Verwendet bitte für aktuelle Mäher bzw. falls ihr die Firmware eures Mähers kürzlich aktualisiert habt, den aktuellen Release-Candidate der Robonect-Firmware: https://fw.robonect.de/?latest Diese wird in ein paar Tagen als offizielle Firmware verfügbar sein. (Stand: 03.04.2024)
Mowing times not being updated
- shadowkiller
- Forum-Veteran
- Beiträge: 4475
- Registriert: Do 11. Jan 2018, 08:42
- Wohnort: Würzburg
- Mäher: Husqvarna Automower 315
- Firmware des Mähers (MSW): MSW 10.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: 1.3 (WLAN 1.7.4)
- hat sich bedankt: 160 Male
- wurde gedankt: 134 Male
Mowing times not being updated
If using extend mowing time, mowing times are no longer logged. This is because Robonect uses the manual mowing mode for this, where no logging of mowing times is used by the mower. Robonect only shows, what the mower is logging.
So this is a normal behavior, not a bug.
So this is a normal behavior, not a bug.
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)