Hello !
I have bought a used H30x module to my R40li.
I can get to the ZeroConf loader but after loading firmware I cant access the webpage.
I can ping the H30x card so IP connection exists, I have tried dis/connect from WLAN, CRTL+F5 to force a reload but nothing helps.
I have tried the 0.9 and 0.4b firmware, previous owner said the card does not support higher FW then 0.9, dont know if that is correct.
A screenshot from ZeroConf browser exist here: http://themax.se/tmp/h30x.jpg
Would be great to get this up running during this weekend if possible, since its in my cottage and I dont visit it so often.
Brg.
No web access after firmware upload [EXPLAINED]
-
- Forum-Anfänger
- Beiträge: 2
- Registriert: Sa 13. Mai 2017, 17:49
- Mäher: Gardena R40Li
- Firmware des Mähers (MSW): MSW 4.xx.xx
- Herstellungsjahr: 2012
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: 0.9e
No web access after firmware upload [EXPLAINED]
Zuletzt geändert von shadowkiller am Do 30. Apr 2020, 22:37, insgesamt 2-mal geändert.
Grund: correct topic
Grund: correct topic
- SenfmitHonig
- sehr erfahrener Forum-Nutzer
- Beiträge: 457
- Registriert: So 30. Okt 2016, 22:39
- Wohnort: 943xx
- Mäher: Husqvarna Automower 430X
- Herstellungsjahr: 2016
- Robonect-Modul: Robonect Hx (Rev.2)
- Robonect Firmware: V1.3
- hat sich bedankt: 4 Male
- wurde gedankt: 34 Male
Re: No web access after firmware upload
get the latest firmware!
Install according to instructions
https://forum.robonect.de/viewtopic.php?f=37&t=3142
The latest version should work for you! --> Then you can install the WLan driver.
Install according to instructions
https://forum.robonect.de/viewtopic.php?f=37&t=3142
The latest version should work for you! --> Then you can install the WLan driver.
Bei WLAN-Problemen kann auch der WLAN-Treiber aktualisiert werden. (Vorraussetzung, ZeroConf V1.4 und mindestens Applikation V1.2_RC0 sind zuvor installiert)
-
- Forum-Anfänger
- Beiträge: 2
- Registriert: Sa 13. Mai 2017, 17:49
- Mäher: Gardena R40Li
- Firmware des Mähers (MSW): MSW 4.xx.xx
- Herstellungsjahr: 2012
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: 0.9e