Hi! I have a McCulloch R1000. Been working perfectly until this morning. All of a sudden it could not find home. I have two sets of loops that I switch between with a Relay. One loop worked fine but the other complained about F-signal.
So I tried to generate a new loop signal and now all signals are 0. Quality etc = 0. I put it in the charger and I get 2 on the N-signal.
https://imgur.com/a/u0RvVDJ
Why did it become 0 when I generated a new signal? Is that a bug?
Thanks!
No loop signal efter new loop signal
- shadowkiller
- Forum-Veteran
- Beiträge: 4475
- Registriert: Do 11. Jan 2018, 08:42
- Wohnort: Würzburg
- Mäher: Husqvarna Automower 315
- Firmware des Mähers (MSW): MSW 10.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: 1.3 (WLAN 1.7.4)
- hat sich bedankt: 160 Male
- wurde gedankt: 135 Male
Re: No loop signal efter new loop signal
The N-signal shows the near wireless signal, which is sended by the charging station. If You setting for “finding charging station” is set to 0m, it will be low. This is recommended for charging stations not places inside the lawn, like the manufacturer wants to place it.
Check this setting and play around with it and you’ll see how it effects.
The F-signal shows the far wireless signal, which is also sended by the charging station.
Both signals have nothing to do with the search cables‘ signals.
For further information please use google to translate informations about the signals here:
Erklärung der Schleifensignale
Check this setting and play around with it and you’ll see how it effects.
The F-signal shows the far wireless signal, which is also sended by the charging station.
Both signals have nothing to do with the search cables‘ signals.
For further information please use google to translate informations about the signals here:
Erklärung der Schleifensignale
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)