First, I am sorry if this has been discussed before.
On my 430x I have 2 guides. In the menu on the automover I can set corridor for "Boundary", "Guide 1" and "Guide 2".
In Robonect web interface it is "Boundary Left", "Boundary Right" and "Guide".
Left and right does not make sense to my 430x.
And Guide value is only one digit, the value "Shortest distance:" is not displayed in Automower menu.
But most of all I miss the option to set value for guide 2.
Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
. Achtung! Verwendet bitte für aktuelle Mäher bzw. falls ihr die Firmware eures Mähers kürzlich aktualisiert habt, den aktuellen Release-Candidate der Robonect-Firmware: https://fw.robonect.de/?latest Diese wird in ein paar Tagen als offizielle Firmware verfügbar sein. (Stand: 03.04.2024)
[BESTÄTIGT] Corridor width - No Guide 2 option
-
- Administrator
- Beiträge: 2907
- Registriert: Di 19. Jan 2016, 18:34
- Wohnort: Kiel
- Mäher: Gardena SILENO City 500
- Firmware des Mähers (MSW): MSW 11.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: stets die Allerneuste :-)
- hat sich bedankt: 1 Mal
- wurde gedankt: 60 Male
- Kontaktdaten:
Re: [BESTÄTIGT] Corridor width - No Guide 2 option
Thank you. That you can select individuial values for left and right boundary was my intention.
In Beta 5, i added also the values for Guide-Wire 2 and 3.
In Beta 5, i added also the values for Guide-Wire 2 and 3.
Werbefläche zu vermieten.