Hey
My 315 have not been updated since 2018/2019. I have observed that my mower have trouble following the guide and boundary wires. No matter the settings of corridor widths, my mower seems to have it's own agenda. I have tried to set the corridor width to be max 1 but sometimes it nevertheless runs with large distance to the wire (e.g. the guide) making considerably left/right turns as if the corridor width was set to 9. Other times it runs correctly directly on wire, as it is supposed to do. My issue is, if the corridor width is too large, my mower will easily loose its track and then "get lost".
It has always been like that, but now I'm getting reel tired of this malfunction, so I would like to getting it updated hoping this will sort
OUT a few things. Since the error has always been there I don't think it is due to some kind of error the wire sensor circuit board.
So.... when a dealer connect the mower to a computer (
Auto Check 3) I guess the dealer doesn't need to open up the entire mower, right? So he won't actually see the red Robonect module?
But will
Auto Check 3 still be able to do its update process even though Robonect is still connected to the motherboard?